The elevator is stationary, and the LCD screen displays the malfunction < RST Connected Enable Phase COR >. The elevator control board does not accept call registrations.

-Access the programming mode and navigate to program < P12: Phase Sequence >. Use the (+) button to enable the program by setting it to <ON>, then press ENTER to save the changes. To exit the programming mode, press RESET.

 

-If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.

The elevator control board experiences prolonged delays in registering calls and maneuvering the elevator car to the designated floors.

-Access the programming mode and navigate to program < P7: Wait Time >. Use the (-) push button to reduce the delay time (s), then press ENTER to save the changes. To exit the programming mode, press RESET.

 

-If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.

The elevator control board does not execute any internal registrations (COP) and only executes external registrations (LOP) and the malfunction < C > appears on the LCD screen.

-Access the programming mode and navigate to program < P13: Key Code >. Use the (-) push button to disable the program by setting it to < OFF >, then press ENTER to save the changes. To exit the programming mode, press RESET.

 

-If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.