- Access the programming mode and navigate to program < P12: Phase Sequence >. Use the (+) button to enable the program by setting it to , then press ENTER to save the changes. To exit the programming mode, press RESET.
- If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.
- Access the programming mode and navigate to program < P7: Wait Time >. Use the (-) push button to reduce the delay time (s), then press ENTER to save the changes. To exit the programming mode, press RESET.
- If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.
- Access the programming mode and navigate to program < P13: Key Code >. Use the (-) push button to disable the program by setting it to < OFF >, then press ENTER to save the changes. To exit the programming mode, press RESET.
- If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.
- Access the programming mode and navigate to program < P4: Door Type >. Use the (+) and (-) push buttons to enable the program < Door: Manual >, then press ENTER to save the changes. To exit the programming mode, press RESET.
- If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.
- Access the programming mode and navigate to program < P8: CAM Time >. Use the (+) push button to increase the wait time (s) of the program < CAM Close >, then press ENTER to save the changes. To exit the programming mode, press RESET.
- If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.
- Access the programming mode and navigate to program < P5: System Type >. Use the (+) and (-) push buttons to activate the program < System: Hydraulic >. Press ENTER to redirect to the < Relevel > program to return the car to the designated stop level. Use the (+) and (-) push buttons to enable the program by setting it to < Relevel: 1 ON >, then press ENTER to save the changes. To exit the programming mode, press RESET.
- Check that the 'STP' LED on the elevator control board is not lit when the elevator car stops on a floor. If there's an issue with the magnetic slide positions in relation to the floor levels, it needs to be corrected.
- If the preceding step is executed and the issue persists, kindly reach out to our technical support team for assistance.